跳至主要内容

The blister

Step 1: collect Wood mould.

Step 2： sand the edges of wood mould
Step 3: put metal between two wood moulds, tighten the screws and hit it .

Step 4: make the line around it more crispy

Step 5 : use metal cutter to cut edge and polish it.



评论

发表评论

此博客中的热门博文

Tutorial for the Torus and Reflection

Step 1：Preparation Use  the guillotine to cut  the aluminium sheet to the size what you want. Step 2: Use the cylindrical wood as template to bend the aluminum sheet, give it a initial circular shape. Step 3: Use  round plastic hammer to hit the mid part of the sheet, shape it to a concave shape (hit the sheet uniformly, keep the curving shape of the sheet.) Keep hitting until  the whole mid part of sheet is concave (shows in next picture) Step 4: This is the time to make the two sides of sheet concave. First, use hammer to hit the side of this curve part, make it curve upward. ( use hand to hold the sheet stand, this will be easy to concave this part) Give an initial curve shape of the sheet and do next step. Step 5:  Refine the reverse curve. After defined all the parts of the sheet,  use a polishing hammer with a rounds metal stand to make the curve part more accurate and smooth. C arefully stretch and shap...
发表评论
阅读全文

The bowl

Step 1: Cut out a circle template. And using mark pen to draw 2 smaller circle parallel. Step 2: Start to hit the side of outer circle Step 3: Use the sandbag and hammer to make the bowl smooth and deep. Step 4：Use englishweel  and metal dome to make it looks better Step5 : trim the edge Step 6：repeat step 4 Step 7：Use metal polish to clean and polish bowl. TEST:
发表评论
阅读全文

The Torus

Step 1: put metal on the cylindrical , bend it. Step 2: use hammer to hit the mid part of metal. Step 3: use sandbag and hammer to hit the side of the sunken part. make it curve upward. Step 4: hit the smaller curved parts on the bending steel Step 5: use englishwheel to make it smooth. Step 6: Polish it .
发表评论
阅读全文