Heming Yang BEIL0014

Step 1: collect Wood mould. Step 2： sand the edges of wood mould Step 3: put metal between two wood moulds, tighten the screws and hit it . Step 4: make the line around it more crispy Step 5 : use metal cutter to cut edge and polish it.

Step 1 use metal cutter to cut the metal according to wood template Step 2: Polish each sides, make it smooth. Step 3: use wood template and hammer to hit each side , make it upward. Step 4: Trim the edge Step 5 : Fail!!!!!  can not match my partner's tary. Step 6: make another one

Step 1: put metal on the cylindrical , bend it. Step 2: use hammer to hit the mid part of metal. Step 3: use sandbag and hammer to hit the side of the sunken part. make it curve upward. Step 4: hit the smaller curved parts on the bending steel Step 5: use englishwheel to make it smooth. Step 6: Polish it .

Step 1: Cut out a circle template. And using mark pen to draw 2 smaller circle parallel. Step 2: Start to hit the side of outer circle Step 3: Use the sandbag and hammer to make the bowl smooth and deep. Step 4：Use englishweel  and metal dome to make it looks better Step5 : trim the edge Step 6：repeat step 4 Step 7：Use metal polish to clean and polish bowl. TEST: